Overview
The Rulers are provided to accurately draw out,
size, and align objects. You can also move the Rulers to
any position in the Drawing area, reset their 0,0 origin
point and hide them away from view. The Rulers are intuitive
as they automatically rescale as you zoom in and out and
also update with the current measurement units.
Click on the Gripper (as
shown directly above at the end of each ruler) and
Hold Down the mouse button and Drag the
Vertical Ruler Left or Right - or - the
Horizontal Ruler Up or Down to reposition
either as required.
Click on the
SignMaster Cut Application flyout (at
the top) to see where the Grippers are located.
Click on the Reset Origin Tool
(as shown directly above at the start of each ruler) and
Hold Down the mouse button and Drag out
the Crosshair (also shown directly above) to the
Position you wish to set the Rulers 0,0 Point of
Origin.
Click on the
SignMaster Cut Application flyout (at
the top) to see where the Origin is located.
To know the Cursor's
position you will see a line drawn on the ruler at the
same position.
(as shown above in the Application flyout) and the
Rulers will either Hide or Display.
