|
Overview
By default the
cutter that came with SignMaster Cut will be installed
automatically and ready to use when you install the
software. However, you may wish to install an additional
cutter that SignMaster Cut supports, and/or calibrate the
cutter's Laser, or Blade offset you have.
Install another Cutter
To Install
another cutter open the Vinyl Spooler
and click the Cut Options tab as shown
above. Next, click the + Add button (as
shown above) and
follow through the wizard.
Calibrate
To calibrate the
cutter open the Vinyl Spooler and click
the Connection tab as shown above. Next
click the Setup Device button (as shown above) and
select the required Calibration wizard
(as shown directly above).
If you do experience any problems,
see
Troubleshooting
|
