The Installation Process
To install and then activate SignMaster Cut is a 2-Step process, as
follows:
Step 1 -
Install SignMaster Cut with the Program DVD and Product
Serial Number (PSN)
Step 2 -
Open the Gateway and click License to activate SignMaster Cut using the Internet
Note: If the computer you wish to install and activate
SignMaster Cut to is not connected to the internet, we provide you
with a very simple process to remotely activate SignMaster Cut from
any other computer that is connected to the internet i.e. so
long as you can access the internet from anywhere else you can
easily activate SignMaster Cut.
Installing SignMaster Cut
on more than one (1) computer You can install
SignMaster Cut onto as many computers as you like and then design
your work and save it off. However, if you want to output from a
particular computer then it must to be Activated and you are
entitled to one (1) Activation per license. Additional licenses
can be purchased at a substantial discount.
Note: You
can always Deactivate a computer and Activate another.
How
to Install SignMaster Cut and Extras
To
Do the following
Install SignMaster Cut
1.
Insert the SignMaster Cut DVD
into your computer's DVD drive and wait for it to
Auto-run.
If it fails to initiate, click on
the Start button and go to Computer/My Computer and
select the DVD drive with the SignMaster Cut DVD and
double-click on it to initiate Auto-run or right-click
on the DVD icon and click Open/Explore and then click on Install_SignMaster Cut.
2.
Follow the Installation
Instructions and click Next as required and
SignMaster Cut will be installed onto your computer;
If required you
can install SignMaster Cut to another drive
on your system. However, and to avoid
potential problems we recommend you
install SignMaster Cut onto C:\ Drive or
the same drive that you have Windows
installed on.
